SittinSic, QA1, Street Taco Droped!!!!!!!!!

Raiden06BSP · May 25, 2011

Wife hates my truck sometimes so I decided to let her pick the color of the springs. Midnight blue. Street Taco 2 1/4" blocks with 9/16" grade 8 u-bolts and QA1's.

Before

After

X-Run-X-er · May 25, 2011

Nice Bro ! Truck looks ALOT better dropped ! I need to pick up some QA1's myself, I may be following your footsteps soon !

Coupe · May 25, 2011

Looks good......

burnboy · May 25, 2011

Mine straight bottoms out on the slightest dip. I'm gonna have to do air assist so I'm putting 1 3/4 blocks till I get ready for air.

babyboi2284 · May 25, 2011

I like those rims. I had the same setup and my qa1s were set on 6. Any higher and it was too damn stiff and any lower was perfect for bottoming out ALL THE TIME lol. If you have some extra cash then I would get some air assist bags.

BSP06XRU · May 25, 2011

Looks much better! :top:

J_StradaXR · May 25, 2011

nice !!!! :top:

Scarface · May 26, 2011

Looks like its higher in the front.

NUPEPRIME · May 26, 2011

Looking good :top:. Running exact same set up. tha front will settle down a little. no worries

X-Run-X-er · May 26, 2011

My front took about a week to go down fully ... on the 3rd day i was driving it i actually was at a stop light and watched the car next to me get higher lol made me feel really good !

CBRBob · May 26, 2011

Why didnt you get the ones that put the axle back in the center of the wheelwell?

808XR10 · May 26, 2011

looking good bro:top:

how long are those U-bolts that you have?

arizonacatjetton · May 26, 2011

Looks good man i like it

Murderface · May 26, 2011

CBRBob said:
Why didnt you get the ones that put the axle back in the center of the wheelwell?

Good question. Now u know if u have a vibration to look at the carrier bearing and see if it's in a bind

burnboy · May 26, 2011

Yeah. Flip your carrier bearing and it will straighten the drive shaft a bit. Also above your drive shaft is a body brace, cross member piece of metal with a corner of a heat shield held with a 10 mm nut. I had to bend it up as best as I could because the drive shaft was flexing and hitting it when I gun it in first gear from a dig. I just put 1 3/4 blocks and no more bottoming out and all is well.

Raiden06BSP · May 27, 2011

right now i have not bottomed out yet and there is no vibration. qa1's are set to five. i will be rechecking my whole install within the next week to make sure everything is still tight.

burnboy · May 27, 2011

The shocks I believe only adjust on the rebound side. Not compression. You will bottom out.

x20Runner05 · May 27, 2011

That looks sick bro.

NoelsMyKuya · Jun 9, 2011

wow what a difference in height, nice drop man!

triumphx · Jun 9, 2011

What offset are those wheels?

Welcome!

SittinSic, QA1, Street Taco Droped!!!!!!!!!

Member

Member

Active Member

New Member

BaggedXR2284

Old Member

Banned

Active Member

Active Member

Member

Active Member

New Member

New Member

New Member

New Member

Member

New Member

New Member

New Member

New Member

Forum statistics

Online statistics

Stay Connected