i really dont feel like pulling out my trans just for this slight hiss noise iv heard it for a while but it never bothered me until my girl could hear it too lol so now i was just wondering it this happened to anyone eles i have about 30k on a remand tran i put in over a year ago bc i snapped a syncro and got stuck in third. but if i cruzing in 6ths its pretty annoying and ifi drop the clutch and giggle everything around it changes pitch i think its strange lol i asked a few guys at work and everyone wasnt able to help with good ideas .... also the throw out bearing started just started making a chirp noise i doubt its causing it but i plan on getting the over sized for that just figured id look for a tip but i started lol thanks for any input
trans making a hissing noise in 2 4 and 6th
- Thread starter xrbeach13
- Start date
Slywhitty
"Midget Magnet"
- Joined
- Jan 26, 2008
- Messages
- 3,394
- Reaction score
- 8
Gadget
Well-Known Member
- Joined
- Jan 13, 2007
- Messages
- 10,932
- Reaction score
- 173
Have no idea why it would make a noise that is gear specific, but you may want to check the dust shield that covers the tail of the transmission. It is just pressed into place and if it gets a whack it can rub on the propeller shaft and have a rubbing/hissing noise that can drive you nuts until you figure it out.
See if that could be it. If it is just shift it back into place so it does not rub anymore.
G
See if that could be it. If it is just shift it back into place so it does not rub anymore.
G
thanks gadget thats a good idea i think i had to reuse the dust shield when i put the remand trans in. yeah its a strange noise iv never heard in any others only in 2 4 and 6th ill be dropping the trans this friday to do the urd throw out bearing for that annoying squeak lol im happy i at least have an idea to check on thanks again
well i figured out my own problem lol the noise was wind noise. the 2 rear clips that held the rubber shifter boot under the one you can see were broken not holding in the sheet metal so when the shifter was pulled back it would let air sneak in the hole. 2 new clips and screws along with the oversized urd release bearing i put in for the squeak today and all my noises are gone lol for now. thanks for the input gadget the dust shield was secure too
