Search results
-
X
Grey Floor mats
I have a set of front and rear floor mats. They are brand new, never used. $85 for the set of 4 Came out of Grey interior of a 08 X -
X
Rad Red X FOR SALE
2008 Less than 56,000 miles. Daily Driver TRD supercharged. Supercharger ported and pulleyed by Stiegemeier. 2.4 pulley Intake ported, Throttle body ported and throttle shaft cut. 7th injector and 668 mains. APR fuel rails X1 with gas and E85 tune. Strong on E85 340lph fuel pump JMS... -
X
Exhaust exit hole delete
Has anyone found a panel to replace the X's exhaust exit hole? Or has anyone modified it to be deleted with some fiberglass or something?- XR
- Thread
- Replies: 7
- Forum: Exterior Modifications
-
X
fj engine
Trying to find the thread that the guy is selling the 1gr out of his fj to swap in a bowtie. Anyone know where it is?- XR
- Thread
- Replies: 1
- Forum: F/I Mods & Tuning
-
X
fuel pressure drop
Ok, for those that have a aftermarket fuel pressure regulator and an in cab FP gauge, what drop do you see (how many psi) when you hammer down?- XR
- Thread
- Replies: 16
- Forum: F/I Mods & Tuning
-
X
Gaylord
Is the Gaylord speedster cover worth it? Anyone got pics?- XR
- Thread
- Replies: 5
- Forum: Exterior Modifications
-
X
URD supercharger and E85
Has anyone with a URD supercharger system ran E85? I am currently TRD supercharged and running E85 I have been contemplating pulling the trigger on a URD setup but still want to run my beloved corn fuel. An thoughts?- XR
- Thread
- Replies: 24
- Forum: F/I Mods & Tuning
-
X
Lid Seal
On the TRD blower the charge cooler lid seal. Its like a foam rubber, what would one use to bond a new seal to the cooler?.- XR
- Thread
- Replies: 13
- Forum: F/I Mods & Tuning
-
X
320 LPH Fuel Pump
Does anyone know if I can run the 320lph pump with a factory regulator?. I run E85- XR
- Thread
- Replies: 1
- Forum: F/I Mods & Tuning
-
X
Third member
What is the lowest gear ratio that T56 guys are running in the rear end. Mine is 4.30 thinking might go lower, but man that's a ton of driveshaft speed. Thoughts?- XR
- Thread
- Replies: 13
- Forum: F/I Mods & Tuning
-
X
Fidanza flywheel
I am about to pull out my T56. I have a Fidanza flywheel sitting on the shelf. I am thinking about finally installing it, I will be there anyway. Has anyone had any problems with the Fidanza and T56 combo? I thought it was a little weird that the pilot bearing is a slip fit rather than a...- XR
- Thread
- Replies: 11
- Forum: F/I Mods & Tuning
-
X
T56
Anyone that has a T56.... Do you know the distance from the tip of the pressure plate fingers to the end of the APR bell housing? Has anyone had any grinding problems? My T56 Mag sometimes comes out of 4th and grinds at times when I am heavy handed. I have spoke with a few guys and...- XR
- Thread
- Replies: 35
- Forum: F/I Mods & Tuning
-
X
Valve Cover Paint?
Has anyone painted there valve covers? If so, what paint is best matched to use for the Red X? Thanks
