Detective_Dan's Build Round 3

Detective_Dan

New Member
both of these videos were just before i installed the exhaust, so, its a stock evo.

(please excuse my cameraman yelling "VTEC!!!" it was an inside joke and had us laughing all night)


[ame]http://www.youtube.com/watch?v=WlBXLYNsq2Q[/ame]
[ame]http://www.youtube.com/watch?v=ouKErRiWP4s[/ame]
 

Detective_Dan

New Member
Lol. Consistent 14.1's but I didn't launch against the ms3, that run was a 14.4.

Once I get it tuned, it will be low 13's because it will remove the first gear limiter, letting it launch much harder
 
Last edited:

Sproulesxrunner

Active Member
got my new license plate in today, I just set it in the grill for the pic. mount location is on the rear



Beautiful front end on that evo sir. :top: Too bad you guys have to have a front license plate. Would the position of the license plate there block any of the intercooler? I don't know much about that stuff but looks sick dude. :crinklehair:
 

Detective_Dan

New Member
Beautiful front end on that evo sir. :top: Too bad you guys have to have a front license plate. Would the position of the license plate there block any of the intercooler? I don't know much about that stuff but looks sick dude. :crinklehair:

We don't have a front plate. I just set it there for the pic. Technically the my evo was a Texas car and required a front plate from the original owner. If I had to mount one up front, I have a bracket that goes where those 3 black plugs are at on the front drivers side bumper.

And yes if I mounted it where it is set in the pic, it would block almost half of the intercooler lol
 
Top