StreetTaco
New Member
- Joined
- Jul 7, 2020
- Messages
- 18
- Reaction score
- 14
I am trying to add an oil pressure sensor in the in place of the right side allen-keyed plug under the oil filter plate. I found the info and have purchased a 1/2" male NPT to 1/8" female NPT adapter/bushing. I first tried to thread the adapter/sensor combination as a unit but was blocked by filter drain spout. I then tried to put just the adapter in but cannot tell if I have sufficiently threaded the adapter into the port for lack of clearance for a wrench and I cannot tread the sensor into the adapter for lack of clearance from the filter drain spout. I have found a different adapter that does not have wrench contacts but I am concerned that if I have to remove the sensor it will remain in filter housing and then create problems reinstalling. Does anyone who has done this have suggestions for accomplishing this? Thanks in advance!
Attachments
Last edited: