LS2 swap

[kwigs160966]

 

[kwigs160966]

 

[kwigs160966]

A little glimpse of the powder coating

 

[azburnin]

Looks Like good work man!

 

[kwigs160966]

Looks Like good work man!

Thanks. progress has definitely slowed down. I have almost everything I need except a clutch and headers mostly I just need more time to sit down and actually finish it off

 

[Torspd]

How many splines are there on the output shaft?

 

[kwigs160966]

How many splines are there on the output shaft?

It's a 27 spline I debated swapping to the ssr main shaft but ended up leaving it.

I have upgraded to a steel 3/4 shift fork and bronze shift fork pads though

 

[Torspd]

Good deal on the upgrades. :top:

Where did you get your output shaft seal?

 

[kwigs160966]

Good deal on the upgrades. :top:

Where did you get your output shaft seal?

It took a while to track one down. GM didn't have any but I ended up with one from eBay and one from thegearbox.com the one from eBay was the wrong one though. The one I am going to use is a tremec part. I think... May have to double check the box

 

[Torspd]

www.tickperformance.com

If you haven't already heard of them.

 

[kwigs160966]

The first test fit

 

[kwigs160966]

Transmission all put back together waiting on a rear main bearing to come in though

 

[kwigs160966]

Side profile

 

[Torspd]

Now that there looks beautiful.

 

[kwigs160966]

Thanks. It's taken a lot of work to get to this point but still a lot to go. Mostly the fabrication, motor mounts, trams mount and rad support. I still need to buy headers and and a clutch too plus lots of little things

 

[Redlantern]

Looks like a tight fit. How much clearance you have for your headers?

 

[bobber bill]

Looks incredible!

 

[iniazy]

Eye candy! This looks like it fits better than the V6 it came with.

 

[Doublld]

Thanks. It's taken a lot of work to get to this point but still a lot to go. Mostly the fabrication, motor mounts, trams mount and rad support. I still need to buy headers and and a clutch too plus lots of little things

i bought a retrofit weld in style motor mount that worked flawlessly with my swap. i can try and find the company and part number if youd like

 

[kwigs160966]

i bought a retrofit weld in style motor mount that worked flawlessly with my swap. i can try and find the company and part number if youd like

That would be awesome. I have a set right now but I'm not sure how they are going to work out