Recent content by 87aaron
-
8
New throwout bearing already failing
So did the newer production since the tsb get upgraded parts, or should I expect to get tob chirp?- 87aaron
- Post #44
- Forum: N/A Mods & Tuning
-
8
New throwout bearing already failing
So, has Toyota fixed the problem in new production or is my 2013 going to have the same issue? I've been thinking about buying the Toyota extended warranty before my factory warranty is up.- 87aaron
- Post #40
- Forum: N/A Mods & Tuning
-
8
Stock tire issue
Yeah, it's the stock tires. They did at least attempt to balance them as they chipped the wheel finish taking the weights off. The have a road force balancer which should catch out of round. Out of round should also vibrate consistently.- 87aaron
- Post #3
- Forum: OEM Wheels/Tires
-
8
Stock tire issue
2013 X with 11K miles and stock wheels and tires. The truck feels like it has a balance issue - vibration from around 40-50 mph and from 70 on up. But, it is intermittent. The other day, I drove 20 miles or so on the highway in the morning and it rode smooth. 4 hours later, the same drive...- 87aaron
- Thread
- Replies: 2
- Forum: OEM Wheels/Tires
-
8
Stock 2013 on G-Tech Pro
Keep in mind my 4 cyl was a 99 2.4 5 speed reg cab 5 lug. It may have been down 100 hp, but it was also more than 1000 pounds lighter.- 87aaron
- Post #8
- Forum: Stock Performance/Mechanical
-
8
Stock 2013 on G-Tech Pro
Actually the GTech is pretty good if setup right. Luckily the stock torque peak is 266 at 4000. That converts to 202 flywheel hp at 4000, which would be right around 160 net hp after driveline and wind resistance loss. So my run as per the GTech instructions produced good results. Still...- 87aaron
- Post #6
- Forum: Stock Performance/Mechanical
-
8
Stock 2013 on G-Tech Pro
Did some math - 266 ft lbs at 4000 rpm is 200 hp. 20% driveline and wind resistance loss would put 160. I guess I'll have to find more road for a full pull and 1/4 mile.- 87aaron
- Post #2
- Forum: Stock Performance/Mechanical
-
8
Stock 2013 on G-Tech Pro
I know my testing is flawed, but I'm scratching my head at the results. Yes, the G-Tech is not perfect, but I've always had it test relatively close in both times and hp if setup correctly. The truck is a stock 2013 with 1800 miles on it. I've always felt it's slower than low 15 sec, but...- 87aaron
- Thread
- Replies: 7
- Forum: Stock Performance/Mechanical
-
8
Seat covers for 2013
Sorry to bring this back from the dead, but I really want to get seat covers now as I somehow got a small stain on the passenger seat. Wet Okoles are too expensive and I don't need neoprene. I just want something relative light to protect the seats from everyday wear. Does anyone make a nice...- 87aaron
- Post #9
- Forum: Interior Modifications
-
8
Selling my X-runner
The baby will fit with the right car seat, the passenger just has to scoot up - hate for you to sell it if it could still work for you. Good Luck -
8
New member with one of the last to be built
I picked it up a couple weeks ago, but things have been hectic. Here you go.- 87aaron
- Post #23
- Forum: New to the Underground
-
8
Sarasota FL Anyone?
This will be an extended warranty daily driver for the foreseeable future, so I'd only do the TRD if it doesn't affect the extended warranty. I've gotten to the point in life where I like to work on vehicles occasionally, but it's nice to just have something that will start and run, and if it... -
8
Sarasota FL Anyone?
Got my 30, so I'll be quiet. Hopefully, I'll have the truck this weekend. Now, I'm debating whether I need a SC and Truetrac. -
8
New member with one of the last to be built
What's the last 6 of your VIN?- 87aaron
- Post #9
- Forum: New to the Underground
-
8
Synthetic vs Dino in 2013 6 speed
The manual for 99 said GL-4 or GL-5, Mobil1 is GL-5.- 87aaron
- Post #4
- Forum: Fluids & Maintenance
