Matt's06
New Member
- Joined
- Jan 14, 2007
- Messages
- 802
- Reaction score
- 0
I have 2" blocks in the back. Took a little longer then I thought it would. You will need a grinder with a cut off disc and an air hammer. I just cut the head of the rivets off and air hammered them out. I started out with just a punch and a hammer. That was a bad idea. It was taking forever and wore me out pretty quick. I would recomend using a torch to heat up the surrounding area. I did not have one, I managed to do without. Also don't forget to sheild the gas tank with something when you cut the rivets and paint the parts of the frame that you might touch with the grinder. So far I have not bottomed out. :rock: I used to bottom out all the time even with my trimmed low-pro bump stops.
Last edited: