which nozzle are you using? 6 gph?
what pressure pump is that?
what are your settings for when it begins to spray?
what % METHANOL?
are you worried about the methanol corroding the sc impellers?
VERY INTERESTED :top:
Right now I have the 375 ml/min nozzle. I might go down to 225 ml/min but will do couple of dyno runs just to see where I am at. The pump is a 150 psi pump. I got the controller to start around 3k rpm and progressively up to full at red line. Right now I am running around 30% percent methanol window washer fluid with HEET additive. Can't really find high concentration of Methanol Washer fluid around here in the South. Heard it was only available up north to prevent from freezing up. So I will eventually make my own. I really would like to run around 80% Methanol concentration. In the past I have been running 100% Methanol but I couldn't find any shop that is open this weekend.
This is my 3rd methanol kit. Never have a problem running it. The mist is so fine and the heat involved, there isn't really any condensation left on the blade or intake.
Anyways, the whole purpose of me running Methanol injection is PRIMARILY because I run a higher boost with the URD pulley. With Toyota flash, I know it would run lean.